This command displays the system's routing table. An example is shown next.
ras> ip route show
dest
------------------ ---------- --------------- ------ ----------------
123.23.15.0/24
123.23.19.233
192.168.1.0/24
default
28.2.8 ip show Command
Syntax:
ras> ip show
Use the command to display the current management IP settings. An example is shown next.
ras> ip show
interface
--------- --------------- --------------- ----
inband
outband
gateway: 123.23.15.254
28.2.9 ip set Command
Syntax:
ras> ip set inband|outband <ip-address>[/<netmask>] [<inband-vid>]
where
inband
outband
[<inband-
vid>]
This command sets the system's IP addresses and in-band management VLAN (CPU). You
can only manage the system through ports that are members of the management VLAN.
By default, you can access the management VLAN from all of the IES's in-
band ports since they are all in the management VLAN. If you need more
security, please see the following example.
MSC1000G/1024G/1224G Series User's Guide
interface
gateway
outband
123.23.15.86
outband
123.23.15.253
inband
192.168.1.2
outband
123.23.15.254
interface ip
netmask
192.168.1.2
255.255.255.0
123.23.15.86
255.255.255.0
=
Sets the in-band management IP address.
Sets the out-of-band management IP address (for the MGMT port).
=
Sets the VLAN ID (Identifier) of the management (CPU) VLAN. You must
=
connect to the system through a port that is a member of the management
(CPU) VLAN in order to perform in-band management.
Chapter 28 ip Commands
metric name
1 -
5 statroute1
1 -
1 -
vid
1
-
661