Shdsl Port Setup Advanced - ZyXEL Communications MSC1024G Series User Manual

Managment switch card

Hide thumbs Also See for MSC1024G Series:

Table of Contents

Chapter 11 Subscriber Port Setup Screens

11.10.2 SHDSL Port Setup Advanced

Click Port > SHDSL in the navigation panel to open the SHDSL Port Setup screen. Click the

Setup button to open the following screen. Use this screen to configure an SHDSL port's

detailed settings.

Figure 152 SHDSL Port Setup: Advanced

The following table describes the fields in this screen.

Table 100 SHDSL Port Setup: Advanced

SHDSL Profile

Stuc Alarm Profile

Click this to return to the previous screen.

Click Apply to save the changes in this screen to the system's volatile memory.

The system loses these changes if it is turned off or loses power, so use the

Config Save on the navigation panel and then the Save button to save your

changes to the non-volatile memory when you are done configuring.

Click Cancel to begin configuring the screen again.

Select this check box to turn on this port.

Select a profile of SHDSL settings (such as the transfer rate, wire pair and signal

to noise ratio settings) to assign to this port. Use the SHDSL Profile screen to

configure SHDSL port profiles.

Select an alarm profile to define the thresholds that trigger an alarm on the port

when exceeded. This alarm profile is for the whole span. This is the entire

connection including any SHDSL regenerators that might be located between the

STU-C (SHDSL Termination Unit - Central) and STU-R (SHDSL Termination Unit -

Remote) end points. An SHDSL regenerator amplifies the SHDSL signal in order

to increase the connection distance.

Select an alarm profile to define the thresholds that trigger an alarm on the port

when exceeded. This alarm profile is for the STU-C (SHDSL Termination Unit -

Central) end point.

MSC1000G/1024G/1224G Series User's Guide

Msc1224g series Msc1000g series