ZyXEL Communications MSC1024G Series User Manual page 203

Figure 118 Static MAC Multicast
The following table describes the related labels in this screen.
Table 71 Static MAC Multicast
LABEL
VID
Group MAC
Type a VID and a group MAC and click Apply to display entries in the first table.
Index
Card Type
Port
Apply
New
Cancel
Modify
Delete
VID
Group MAC
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Type the number of the VLAN that incoming packets for this static multicast group
must be tagged with.
Enter the static multicast MAC address.
This column lists the slot numbers of the line cards. Click the number of an active line
card to go to a screen where you can set the membership of each of the card's ports
for this static multicast group.
This field displays the kind of card installed in a slot.
This section lists the VLAN membership setting of each port on each line card. An "F"
indicates that the port is a permanent member of the static multicast group. An "X"
indicates that the port is forbidden (blocked) from joining the static multicast group.
An "-" indicates that the port is a normal member and can join the group dynamically.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
After you click Apply, entries display in the first table so you can edit them. Click New
if you want to configure a different static multicast group.
Click Cancel to begin configuring the screen again.
Select a static multicast group's radio button and click Modify to display the static
multicast group in the table above so you can edit it.
Select a static multicast group's radio button and click Delete to remove the static
multicast group.
This is the number of the VLAN that this static multicast group uses.
This is the static multicast MAC address.
Chapter 10 Multicast Screens
203