ZyXEL Communications MSC1024G Series User Manual page 66

Chapter 3 The Web Configurator
Table 3 Navigation Panel Links (continued)
LINK
LDM
Loopback
IP Ping
IP Trace Route
MLT
CFM Loopback
CFM Linktrace
SELT
OAM Loopback
IMA Loopback
Maintenance
Config Backup
Config Restore
Config Reset
Firmware
Upgrade
Reboot
Multicast
IGMP Setup
Static Multicast
Static MAC
Multicast
MVLAN
Port
ADSL
VDSL
VDSL2
SHDSL
66
DESCRIPTION
This link takes you to a screen where you can perform LDM (Loop Diagnostic
Mode) tests on a subscriber port.
This link takes you to a screen where you can perform an OAM (Operational,
Administration and Maintenance) F5 loopback test on a subscriber port or PVC.
This link takes you to a screen where you can ping a host.
This link takes you to a screen where you can send a traceroute packet to an IP
address and use the response to determine the path a packet takes to that IP
address.
This link takes you to a screen where you can test the lines connected to VOP
ports.
This link takes you to a screen where you can perform a connectivity fault
management loop back test.
This link takes you to a screen where you can perform a connectivity fault
management link trace test.
This link takes you to a screen where you can perform a SELT (Single End Loop
Test) on a port to check the distance to the subscriber's location.
This link takes you to a screen where you can perform an Ethernet OAM
(Operational, Administration and Maintenance) loopback test to a remote Ethernet
device.
This link takes you to a screen where you can perform an E1, IMA or F5 loopback
test to a remote ADM (Add-Drop Multiplexer) device.
This link takes you to a screen where you can back up your current system
configuration.
This link takes you to a screen where you can restore a previously saved
configuration.
This link takes you to a screen where you can reset the system back to the factory
defaults.
This link takes you to a screen where you can upload a new firmware.
This link takes you to a screen where you can restart the system.
This link takes you to screens where you can enable or disable IGMP proxy or
IGMP snooping and assign IGMP filter profiles to subscriber ports.
This link takes you to a screen where you can configure static multicast group
entries.
This link takes you to a screen where you can configure MAC address-based static
multicast group entries.
This link takes you to a screen where you can configure multicast VLAN.
This link takes you to screens where you can configure the ADSL ports.
This link takes you to screens where you can configure the VDSL ports on VLCs
that follow the VDSL MIB as defined in ADSL Extension Line MIB (RFC 3440).
This link takes you to screens where you can configure the VDSL2 ports on VLCs
that follow the VDSL2 MIB (defined in draft-ietf-adslmib-vdsl2-06).
This link takes you to screens where you can configure the SHDSL ports.
MSC1000G/1024G/1224G Series User's Guide