Table of Contents
Advertisement
Chapter 12 IMA Screens
Table 136 DTPVC Setup (continued)
LABEL
Apply
Cancel
ID
State
Card Type
Up Time
Firmware
12.6.1 The DTPVC Setup Slot Screen
Click IMA > DTPVC in the navigation panel to open the DTPVC Setup screen. Click an
active IMA line card's ID number to open the following screen. Use this screen to view and
delete DTPVCs on IMA groups of the line card.
Figure 204 IMA > DTPVC Setup: Slot
The following table describes the fields in this screen.
Table 137 IMA > DTPVC Setup: Slot
LABEL
UP
Delete
Previous 10
Previous
Page X of X
318
DESCRIPTION
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
This column lists the slot numbers of the line cards. Click the ID number of an
active DSL line card to go to a screen where you can view and delete PVCs from
the line card.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could
be due to the card starting, a firmware upgrade in progress or a malfunction. See
Section 39.7 on page 974
for what to do if the line card stays stuck in the inactive
state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it
was started.
This field displays the current firmware version installed on the line card.
DESCRIPTION
Click this to return to the previous screen.
Click Delete to remove the selected DTPVC(s).
Click Previous 10 to show the preceding 10 pages of information.
Click Previous to show the preceding screen if the information cannot be
displayed in one screen.
This identifies which page of information is displayed and the total number of
pages of information.
MSC1000G/1024G/1224G Series User's Guide
Advertisement
Table of Contents
Troubleshooting
