Switch Commands; Switch Commands Overview; General Switch Command Parameters; Switch Commands Summary - ZyXEL Communications MSC1024G Series User Manual

C
H A P T E R
This chapter shows you how to use the

34.1 switch Commands Overview

The commands configure switching functions and manage the Ethernet interfaces.
switch

34.2 General switch Command Parameters

The following table describes commonly used
Table 346 General switch Command Parameters
NOTATION
profile
ma-name:
md-name
mep-id
34.3 Commands Summary
switch
The following table lists the
administrator privilege level needed to use the command (H for high, M for middle or L for
low).
Table 347 switch Commands
COMMAND
switch bandwidth disable
enable
set
MSC1000G/1024G/1224G Series User's Guide

switch Commands

switch
DESCRIPTION
The profile name configured in profile switch (<=32 characters).
A maintenance association name (<=32 characters).
The name of a maintenance domain (<= 32 characters).
The maintenance association end point identifier (1~8191).
commands. The P column on the right indicates the
switch
<giga-port>
<giga-port>
<giga-port>
<ingress-rate>
<egress-rate>
commands.
command parameter notation.
switch
DESCRIPTION
Turns off bandwidth control on the
specified port(s).
Turns on bandwidth control on the
specified port(s).
Sets the incoming or outgoing bandwidth
control for the specified Gigabit port(s)
(0~1000 Mbps).
ingress-rate: The incoming bandwidth
rate on a port.
egress-rate: The outgoing bandwidth
rate on a port.
34
P
M
M
M
867