Table of Contents
Advertisement
15.17 Switch CFM Screens
Click Switch > CFM in the navigation panel to display the screen shown next. Use this screen
for initial configuration of a CFM (Connectivity Fault Management) domain, to globally
switch this feature on or off and to create an MD. Refer to
information.
Figure 347 Switch CFM
The following table describes the labels in this screen.
Table 256 CFM Maintenance Domain
LABEL
CFM Enable
MD Name
Level
Apply
New
Cancel
Index
MD Name
Level
No. of ma
Modify
Delete
15.17.1 CFM MA Screen
Click an MD index number in the Switch > CFM screen to display the screen shown next.
Use this screen to configure MAs, EP ID.
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Select or deselect the check box and click Apply to turn the CFM feature on or off.
Type a name (up to 31 printable ASCII characters) for this MD. This is for
identification purposes.
Type a level number (0~7) for this MD.
Click Add to add the settings as a new entry in the summary table below.
Click New to start configuring the MD setting again.
Click Cancel to reset the fields.
This field displays the index number for the record in this summary table. Click an
index number to configure the associated MA under this MD.
This field displays the descriptive name of the MD.
This field displays the level number of the MD.
This field displays the number of the MAs under this MD.
Select an MD and click Modify to bring the MD information in this screen for
modification.
Select an MD and click Delete to remove an MD.
Chapter 15 Switch Screens
Section 8.1 on page 175
for more
497
Advertisement
Table of Contents
Troubleshooting
