Switch Dot3Ad Enable Command; Switch Dot3Ad Disable Command; Switch Dot3Ad Show Command - ZyXEL Communications MSC1024G Series User Manual

Chapter 34 switch Commands

34.6.4 switch dot3ad enable Command

Syntax:
switch dot3ad enable sub|up [lacp]
where
sub
up
[lacp}
This command turns on link aggregation on subtending or uplink ports.
This example sets the MSC to use link aggregation on the subtending ports. This also copies
the configuration of subtending port one to subtending port two. The system asks you to
confirm if this is what you want to do.
ras> switch dot3ad enable sub
Enabling sub trunking will copy configurations of port sub1 to port sub2
Configurations of port sub2 will be lost!
Do you wish to continue? ('y' to continue)

34.6.5 switch dot3ad disable Command

Syntax:
switch dot3ad disable sub|up
where
This command turns off link aggregation on subtending or uplink ports.
This example sets the MSC to not use link aggregation on the uplink ports.
ras> switch dot3ad disable up

34.6.6 switch dot3ad show Command

Syntax:
switch dot3ad show
This command displays the link aggregation state of the trunk groups.
This command displays the link aggregation state of the subtending and uplink ports.
882
The subtending ports
=
The uplink ports.
=
= Turns on LACP protocol.
The subtending ports
=
sub
The uplink ports.
up =
MSC1000G/1024G/1224G Series User's Guide