Table of Contents
Advertisement
The following table describes the labels in this screen.
Table 23 OUI Filter
LABEL
Slot
Port
Load
Enable
Mode
OUI1.. 10
Apply
Cancel
Copy
ID
State
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Use the drop-down list boxes to select an DSL port on a line card for which you wish
to configure packet type filtering.
Click Load to display the port's current settings.
Select Enable to activate this filter.
Clear this check box to disable the filter without deleting it.
Specify the action on matched frames.
Select accept to allow frames with a matched OUI field in the MAC addresses. The
switch blocks frames with other OUIs not specified.
Select deny to block frames with a matched OUI field in the MAC addresses. The
switch allows frames with other OUIs not specified.
Enter the first three octets of a MAC address in the format xx:xx:xx. For example,
00:0F:FE.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Do the following to copy the settings you configure above to another port or ports.
1. Click Copy.
2. Select to which line card you want to copy the settings.
3. Select to which ports on the line card you want to copy the settings. Use Select
All to select every port. Use Select None to clear all of the check boxes.
4. Click Apply to paste the settings.
This is the slot number of a line card. Click the index number of an active line card to
display the OUI Filter Slot screen where you can view and copy settings from one
port to another port or ports on the selected line card.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be
due to the card starting, a firmware upgrade in progress or a malfunction. See
Section 39.7 on page 974
for what to do if the line card stays stuck in the inactive
state.
Chapter 5 Access Control List Screens
113
Advertisement
Table of Contents
Troubleshooting
