Chapter 21 acl Commands
The following figure shows an example. The asterisk (*) in front of a DHCP server address
indicates that it is the active DHCP server in the VLAN.
ras> acl dhcprelay82 show
dhcp relay status:
dhcp relay mode:
dhcp relay option82 info:
server list:
server set: 1
index
vid
----- ----- ------------------ ------------------
1
ras>
21.4 DHCP Relay Option 82 (Agent Information) Sub-option 2
(Remote ID)
Use the following commands to configure the DHCP relay Option 82 (agent information)
feature, sub-option 2. This feature applies regardless of whether or not the DHCP relay is on.
21.4.1 Option 82 Sub-option 2 Enable Command
Syntax:
ras> acl dhcprelay82 suboption2 enable <vid>
where
<vid>
This command turns on the DHCP relay agent information (Option 82, Sub-option 2) for the
specified VLAN.
21.4.2 Option 82 Sub-option 2 Disable Command
Syntax:
ras> acl dhcprelay82 suboption2 disable <vid>
where
<vid>
This command turns off the DHCP relay agent information (Option 82, Sub-option 2) for the
specified VLAN.
21.4.3 Option 82 Sub-option 2 Set Command
Syntax:
ras> acl dhcprelay82 suboption2 set <vid> <info>
594
disable
both
[NULL]
primary-server
3 192.168.1.10
The ID of the VLAN to which to apply the setting.
=
The ID of the VLAN to which to apply the setting.
=
secondary-server
(*)192.168.1.11
MSC1000G/1024G/1224G Series User's Guide