ZyXEL Communications MSC1024G Series User Manual page 271

Table 111 IPBPVC (continued)
LABEL
Select
Modify
Copy
Delete
VPI/VCI
PVID
Profile
IPBPVC Type
Priority
Apply
Cancel
ID
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Select the radio button in the Select column for an entry and click Modify to be
able to edit the entry, Copy to duplicate the entry's settings on another port, or
Delete to remove the entry.
Select the radio button in the Select column for an entry and click Modify to be
able to edit the entry.
Do the following to copy the settings you configure above to another port or
ports.
1. Click Copy.
2. Select to which line card you want to copy the settings.
3. Select to which ports on the line card you want to copy the settings. Use
Select All to select every port. Use Select None to clear all of the check
boxes.
4. Click Apply to paste the settings.
Select the radio button in the Select column for an entry and click Delete to
remove the entry.
Type the Virtual Path Identifier and Virtual Circuit Identifier for a channel on this
port.
Type the VLAN ID to assign to frames received on this channel. This VLAN ID
must be in an IP bridge domain.
Use the drop-down list box to select an ATM profile to use for this channel's
traffic shaping.
Use the drop-down list box to specify the encapsulation type for the PVC.
llc and vc are for a PVC running on Ethernet (IPoE), llc_r and vc_r are for a
PVC running on ATM (IPoA).
Use the drop-down list box to select the priority value (0 to 7) to add to incoming
frames without a (IEEE 802.1p) priority tag.
Click Apply to add or save channel settings on the selected port.
Clicking Apply saves your changes to the MSC's volatile memory. The MSC
loses these changes if it is turned off or loses power, so use the Config Save
link on the navigation panel to save your changes to the non-volatile memory
when you are done configuring.
Click Cancel to start configuring the screen again.
This is the slot number of a line card. Click the index number of an active line
card that supports PVC to display a list of the IPB PVCs on the selected line
card (see Section 11.19.2 on page
Chapter 11 Subscriber Port Setup Screens
273).
271