ZyXEL Communications MSC1024G Series User Manual page 283

The following table describes the labels in this screen.
Table 117 The Port > VoIP SIP Setup > SIP Port Setup Line Card Screen
LABEL
UP
Copy
Apply
Cancel
Port
Enable
Customer Information
SIP Profile
Call Service Profile
DSP Profile
Select
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Click this to return to the Port > VoIP SIP screen.
Use this to assign the selected port's settings to other ports.
1. Click Copy. The following pop-up screen displays.
Figure 176 Copy Port Settings
2. Select the required slot from the drop-down list.
3. Select the port(s) to which you want to copy the settings. Use Select All
to select every port. Use Select None to clear all of the check boxes.
4. Click Apply to copy the settings, or click Cancel to close the window
without saving any changes.
Click this to save your changes to the MSC's volatile memory. The MSC
loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Click this to begin configuring the fields again.
These are the numbers of the line card's ports.
Click a port number to display the Advanced SIP Port Setup screen (see
Section 11.24 on page 284).
Select a check box in this column to activate a port. Select the check box at
the top of the column to activate all of the line card's ports.
Enter information to identify the subscriber connected to this port. You can
use up to 31 printable English keyboard characters (including spaces and
hyphens).
Select the SIP profile the port is to use. If you have not configured any
profiles, only the default profile DEFVAL can be selected. Configure SIP
profiles in the Profile > VoIP SIP screen.
Select the call service profile the port is to use. If you have not configured
any profiles, only the default profile DEFVAL can be selected. Configure
call service profiles in the Profile > VoIP SIP CALLSVC screen.
Select the digital sound processing profile the port is to use. If you have not
configured any profiles, only the default profile DEFVAL can be selected.
Configure DSP profiles in the Profile > VoIP DSP screen.
Use this column to choose a port from which you want to copy settings.
Chapter 11 Subscriber Port Setup Screens
283