Vdsl Port Setup Advanced - ZyXEL Communications MSC1024G Series User Manual

The following table describes the fields in this screen.
Table 85 VDSL Port Setup: Line Card
LABEL
UP
Copy
Apply
Cancel
Port
Enable
Customer
Information
VDSL Profile
Select

11.8.2 VDSL Port Setup Advanced

Click Port > VDSL in the navigation panel to open the VDSL Port Setup screen. Click the
slot number of an active VDSL line card and click a port number to display the configuration
screen. Use this screen to configure an VDSL port's detailed settings.
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Click this to return to the previous screen.
Do the following to copy settings from one DSL port to another DSL port or ports.
1. Use the Select column to choose a DSL port from which you want to copy
settings.
2. Click Copy to display the following screen.
Figure 135 Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the DSL ports on the line card to which you want to
copy the settings. Click Select All to mark all of the port check boxes or click
Select None to clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this
screen. Click Cancel to close the screen without saving changes.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
These are the numbers of the DSL ports on the line card.
To configure advanced port settings, click a port number to display the VDSL Port
Setup screen.
Select a check box in this column to turn on a port. Select the check box at the top
of the column to turn on all of the line card's ports.
Enter information to identify the subscriber connected to this VDSL port. You can
use up to 31 printable English keyboard characters (including spaces and
hyphens).
Select a profile of VDSL settings (such as the transfer rate, interleave delay and
signal to noise ratio settings) to assign to this port. Use the VDSL Profile screen
to configure VDSL port profiles.
Use the Select column to choose a DSL port from which you want to copy
settings.
Chapter 11 Subscriber Port Setup Screens
227