ZyXEL Communications MSC1024G Series User Manual page 290

Chapter 11 Subscriber Port Setup Screens
The fields that display in this screen are the same as those in the H248 Port
Setup screen (see
Figure 182 The Advanced H248 Port Setup Screen
The following table describes the labels in this screen.
Table 121 The Advanced H248 Port Setup Screen
LABEL
UP
Enable
DSP Profile
TEL
Customer Information
Termination
Impedance
Apply
Cancel
290
Section 11.25 on page
DESCRIPTION
Click this to return to the Port H248 Setup Line Card screen.
Select the check box to activate H248-based VoIP on this port.
Select the digital signal processing profile the port is to use. If you have
not configured any profiles, only the default profile DEFVAL can be
selected. Configure DSP profiles in the Profile > VoIP DSP screen.
This field displays the H.248 Termination name of the port. The
Termination name is assigned by the media gateway controller.
Enter information to identify the subscriber connected to this port. You can
use up to 31 printable ASCII characters (including spaces and hyphens).
Enter the name for this port's H.248 Termination. By default, the port's
Termination name is "termX", where X is the port number. Enter up to 31
alphanumeric characters. Spaces are not allowed.
This field displays the default VoIP port AC impedance. The default
impedance value depends on the country code (configured in the VoIP >
Countrycode screen).
If you do not want to use the default impedance, select the required AC
impedance of the VoIP port from the drop-down list.
Click this to save your changes to the MSC's volatile memory. The MSC
loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Click this to begin configuring the fields again.
MSC1000G/1024G/1224G Series User's Guide
285).