Show Gbond Command; Show Igmp Commands - ZyXEL Communications MSC1024G Series User Manual

Chapter 33 show Commands

33.3.10 show gbond Command

Syntax:
show gbond <slot> [<gbond_name>]
This command displays G.bond settings for the card inserted into the specified slot and, if
specified, a G.bond group.
The following example shows G.bond settings on the G.bond group named "gbondgroup1"
configured on the line card in slot 5. The ports 1 and 2 have set in the G.bond group, upstream
(us) and downstream (ds) data rates for DSL lines on these ports are zero.
ras> show gbond 5 gbondgroup1
slot name
port list
------------------------------------------------------------------------------
5 gbondgroup1
1,2

33.3.11 show igmp Commands

Use the show igmp commands to display current IGMP settings and statistics. Use
multicast igmp enable
33.3.11.1 show igmp info Command
Syntax:
show igmp info
This command displays the current IGMP settings and the number of IGMP-related packets
received. The following figure shows an example.
ras> show igmp info
mode is igmpsnooping
number of queries
number of reports
number of leaves
number of unknowns = 0
number of groups
ras>
33.3.11.2 show igmp group Command
Syntax:
show igmp group [<vid> <mcast_ip>]
where
<mcast_ip>
836
to enable IGMP first.
= 0
= 0
= 0
= 0
The multicast IP address.
=
us(kbps) ds(kbps)
0
MSC1000G/1024G/1224G Series User's Guide
0