Switch Setup Qschedule Screen - ZyXEL Communications MSC1024G Series User Manual

Chapter 15 Switch Screens
Table 243 Switch Setup Dot3ad (continued)
LABEL
Apply
Cancel

15.7 Switch Setup QSchedule Screen

Click Switch > Switch Setup > QSchedule to display the screen as shown.
Figure 329 Switch Setup QSchedule
The following table describes the labels in this screen.
Table 244 Switch Setup QSchedule
LABEL
Port
Algo_Type
Queue 0~7
Apply
Cancel
478
DESCRIPTION
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
This column lists the management switch card's Gigabit Ethernet interfaces.
Use this field to set a Gigabit Ethernet interface's queuing algorithm. If trunking is
enabled, you set this for one interface and it applies to the whole trunk group.
Select spq to use Strict Priority Queuing (SPQ). SPQ services queues based on
priority only. When the highest priority queue empties, traffic on the next highest-
priority queue begins.
Select wrr to use Weighted Round Robin (WRR) Scheduling. WRR services
queues on a rotating basis based on their queue weight (the number you configure
in the queue weight fields). Queues with larger weights get more service than
queues with smaller weights.
These fields apply when you select the wrr queuing algorithm in the Algo_Type
field.
Use these fields to set the priority weight (0~15) of each queue on a Gigabit
Ethernet interface (or trunk group if trunking is enabled). The higher a queue's
weight, the more service it gets.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
MSC1000G/1024G/1224G Series User's Guide