This command lets you open the DSLAM's CLI via the cluster manager DSLAM.
The following is an example. After you log into a cluster member, the cluster name and the
member's ID number display in the command prompt.
ras> cluster login 2
Copyright (c) 1994 - 2006 ZyXEL Communications Corp.
24.2.5 cluster member candidate show Command
Syntax:
cluster member candidate show
This command displays potential cluster member DSLAMs that were found by auto-
discovery. The DSLAMs must be directly connected and in the same VLAN group. You must
have also logged into that device and configured it as a cluster member.
A device can only be part of one cluster at a time. If a device is already in another cluster, it
does not display here. Devices that are set to be cluster managers will not be visible.
24.2.6 cluster member candidate flush Command
Syntax:
cluster member candidate flush
This command updates the list of suitable candidates found by auto-discovery.
24.2.7 cluster member delete Command
Syntax:
cluster member delete <id>
where
This command removes the specified cluster member from the cluster.
The following example removes the cluster member DSLAM with ID 3 from the cluster.
ras> cluster member delete 3
24.2.8 cluster member set Command
Syntax:
cluster member set <id> <mac> <password>
MSC1000G/1024G/1224G Series User's Guide
=
The member's ID number (2~8).
<id>
Chapter 24 cluster Commands
625