Port Vdsl Upbo Commands; Port Vdsl Vlan Commands - ZyXEL Communications MSC1024G Series User Manual

• Configures the service provider's VID to 10 and VLAN priority to 7 (highest priority).
ras> port vdsl tls enable 4-5
ras> port vdsl tls set 4-5 10 7

31.34.17 port vdsl upbo Commands

Syntax:
port vdsl upbo <slot-port> <on|off>
This command enables or disables Upstream Power Back Off (UPBO) on the VDSL port(s).
UPBO allows the switch to provide better service in a network environment with telephone
wiring of varying lengths.
The following example enables UPBO on all ports on VDSL line card in slot 4.
ras> port vdsl upbo 4-* on

31.34.18 port vdsl vlan Commands

Syntax:
port vdsl vlan <slot-port> <vid> <registration> <tag>
where
<vid>
<registration>
<tag>
This command sets the port VLAN settings on the VDSL port(s).
The following example sets the VDSL port 5 on the line card in slot 4 to join VLAN 5. The
port also adds a tag to frames.
ras> port vdsl vlan 4-5 5 join tag
MSC1000G/1024G/1224G Series User's Guide
= Enter a VID (VLAN ID) to add this channel as a member.
This must be the VLAN ID of a VLAN that is already configured. The
port that you are configuring must also be set to the fixed status in
the VLAN.
= Enter join to have the port be a member of the specified VLAN.
Enter leave to remove the port from the specified VLAN.
Enter to add a tag to all frames transmitted on this port.
= tag
Enter untag to not add tags.
Chapter 31 port Commands
751