The following example sets the Join Timer to 300 milliseconds, the Leave Timer to 900
milliseconds and the Leave All Timer to 12000 milliseconds.
ras> switch garptimer join 300 900 12000
34.8 switch isolation Commands
Use the
switch isolation
subscriber isolation to block communications between subscriber ports. When you enable
subscriber isolation you do not need to configure the VLAN to isolate subscribers.
Turn on VLAN isolation to block communications between subscribers in different VLANs if
you do not block communications between subscriber ports. For example, you might want to
isolate some VLANs (for example, high-speed Internet) and not isolate other VLANs (for
example, VoIP).
34.8.1 switch isolation show Command
Syntax:
switch isolation show
This command displays the system's subscriber isolation and VLAN isolation settings. An
example is shown next.
ras> switch isolation show
port isolation :disabled
isolated vlan list:
----
5
938
34.8.2 switch isolation enable Command
Syntax:
switch isolation enable
This command turns on the system's subscriber isolation setting. An example is shown next.
ras> switch isolation enable
port isolation :enabled
ras>
34.8.3 switch isolation disable Command
Syntax:
switch isolation disable
MSC1000G/1024G/1224G Series User's Guide
commands to configure the subscriber isolation feature. Use
Chapter 34 switch Commands
887