Vdsl2 Port Setup - ZyXEL Communications MSC1024G Series User Manual

The following table describes the fields in this screen.
Table 95 VDSL Port Setup: PVLAN Setup
LABEL
UP
VID
Etype
Priority
Apply
New
Cancel
The table in the bottom half of the screen lists the PVLANs that the port is a member of.
Modify
Delete
Index
VID
Etype
Priority
Select

11.9 VDSL2 Port Setup

Click Port > VDSL2 in the navigation panel to open the following screen. Use this screen to
configure settings for individual VDSL ports on VLCs that follow the VDSL2 MIB (defined
in draft-ietf-adslmib-vdsl2-06).
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Click this to return to the previous screen.
Enter the VLAN ID (from 1 to 4094) of the VLAN to add to untagged frames of the
protocol specified in this PVLAN configuration.
Enter the four hexadecimal digits that specify the Ethernet type of a specific
protocol. For example, 0806 is the Ethernet type, 0x0806, for ARP (Address
Resolution Protocol) traffic. The system checks for untagged frames with this
Ethernet type and adds the configured VID and priority.
Enter the IEEE 802.1p priority (0 to 7) to add to untagged frames of the protocol
specified in this PVLAN configuration. "0" is the lowest priority level and "7" is the
highest.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click New to set the screen to configure a new entry.
Click Cancel to begin configuring the screen again.
Click Modify to display the selected PVLAN membership entry's settings in the
fields above so you can edit them.
Click Delete to remove the selected PVLAN membership entry.
This is the number of the PVLAN membership entry.
This field displays the number of a VLAN (VLAN ID) to add to untagged frames of
the specified protocol.
This field displays the Ethernet type in hexadecimal.
This field displays the IEEE 802.1p priority to add to untagged frames of the
specified protocol.
Select the radio button of a PVLAN membership entry and then use the Modify
button or the Delete button.
Chapter 11 Subscriber Port Setup Screens
241