Port Enet Dot3Ad Enable Command; Port Enet Dot3Ad Show Command; Port Enet Flowctrl Disable Command; Port Enet Flowctrl Enable Command - ZyXEL Communications MSC1024G Series User Manual

Chapter 31 port Commands

31.10.4 port enet dot3ad enable Command

Syntax:
port enet dot3ad enable <slot> t1|t2|...|t10 [lacp]
This command
lacp to turn on LACP protocol.
This example turns on link aggregation on the t1 trunk group on an ELC in slot 4.
ras> port enet dot3ad enable 4 t1

31.10.5 port enet dot3ad show Command

Syntax:
port enet dot3ad show <slot>
This command displays the link aggregation settings for the Ethernet (ELC) in the specified
slot.
This example displays the link aggregation settings for the Ethernet (ELC) in slot 4.
ras> port enet dot3ad show 4
agg enable type
---- ------ ------- -----------------------------------------------
t1 -
t2 -
t3 -
t4 -
t5 -
t6 -
t7 -
t8 -
t9 -
t10 -

31.10.6 port enet flowctrl disable Command

Syntax:
port enet flowctrl disable <slot-port>
This command turns off flow control on an Ethernet (ELC) subscriber port.
The following example turns off the flow control on port 5 on the ELC in slot 4.
ras> port enet flowctrl disable 4-5

31.10.7 port enet flowctrl enable Command

Syntax:
port enet flowctrl enable <slot-port>
This command turns on flow control on an Ethernet (ELC) subscriber port.
712
rns on link aggregation on the specified subscriber port trunk group. Use
tu
port
static 4-1 4-2 4-3 4-4
static
static
static
static
static
static
static
static
static
MSC1000G/1024G/1224G Series User's Guide