Port Ppvc Commands; Port Ppvc Delete Command; Port Ppvc Member Delete Command - ZyXEL Communications MSC1024G Series User Manual

Chapter 31 port Commands
where
<tx-gain>
<rx-gain>
This command sets the amount of gain to apply to the signal the subscriber transmits (tx) or
the signal the subscriber receives (rx) for the specified port and/or slot.
The gain is measured in tenths of a decibel and the range can be from -200 to 200. Enter a
negative value to decrease the volume.
The following example sets slot 3's port 5 to use a gain of 10 decibels for the signal from the
subscriber and a gain of 6 decibels for the signal going to the subscriber.
ras> port pots gain 3-5 100 60

31.26 port ppvc Commands

Use the
port ppvc

31.26.1 port ppvc delete Command

Syntax:
port ppvc delete <slot-port-vpi/vci>
This command removes a PPVC. Removing a PPVC also deletes all of the member PVCs.
The following example removes a PPVC with VPI 8 and VCI 35 for port 5 on the line card in
slot 7.
ras> port ppvc delete 7-5-8/35

31.26.2 port ppvc member delete Command

Syntax:
port ppvc member delete <slot-port-vpi/vci> <vpi/vci>
where
<slot-port-vpi/
vci>
<vpi/vci>
This command removes a PVC from a PPVC.
732
= This sets the amount of gain (increase in volume) you want to apply to the
signal received from the subscriber and transmitted to the SIP server.
This is the amount of gain (increase in volume) you want to apply to the
=
signal received from the SIP server and transmitted to the subscriber.
commands to configure PPVCs and add and remove member PVCs.
The slot and port(s) and VPI/VCI of the PPVC.
=
The VPI and VCI of the individual PVC that you are removing from
=
the PPVC.
MSC1000G/1024G/1224G Series User's Guide