Dscp Overview; Switch Dscp Commands - ZyXEL Communications MSC1024G Series User Manual

Here is an example.
ras> switch dot3ad show
agg enable
---- ------ ------ -----------------------------------------------
tsub -
tup -
"V" displays for trunking groups that have link aggregation enabled "-" displays for ports that
do not.

34.6.7 DSCP Overview

DiffServ Code Point (DSCP) is a field used for packet classification on DiffServ networks.
The higher the value, the higher the priority. Lower-priority packets may be dropped if the
total traffic exceeds the capacity of the network.

34.6.8 switch dscp Commands

Use the
switch DSCP
IEEE 802.1p mapping for the Gigabit Ethernet interfaces.
34.6.8.1 switch dscp disable Command
Syntax:
switch dscp disable <giga-port>
This command turns off DSCP to DSCP mapping and DSCP to IEEE 802.1p mapping on a
Gigabit Ethernet interface.
The following example turns off DSCP to DSCP mapping and DSCP to IEEE 802.1p mapping
on the subtending 1 Gigabit Ethernet interface.
ras> switch dscp disable sub1
34.6.8.2 switch dscp enable Command
Syntax:
switch dscp enable <giga-port>
This command turns on DSCP to DSCP mapping and DSCP to IEEE 802.1p mapping on a
Gigabit Ethernet interface.
The following example turns on DSCP to DSCP mapping and DSCP to IEEE 802.1p mapping
on the subtending 1 Gigabit Ethernet interface.
ras> switch dscp enable sub1
MSC1000G/1024G/1224G Series User's Guide
type port
static sub1 sub2
static up1 up2
commands to show and configure the DSCP mapping and DSCP to
Chapter 34 switch Commands
883