Chapter 34 switch Commands
where
This command sets a Gigabit Ethernet interface(s) to use VLAN trunking in order to accept
frames with any VID.
The following example sets the subtending 1Gigabit Ethernet interface to use VLAN trunking.
ras>
switch port vlantrunk enable sub1
34.13.2 switch port vlantrunk disable Command
Syntax:
switch port vlantrunk disable <giga-port>
where
<giga-port>
This command sets a Gigabit Ethernet interface(s) to not use VLAN trunking so the port only
accepts frames with registered VIDs.
The following example sets the subtending 1Gigabit Ethernet interface to not use VLAN
trunking.
ras>
switch port vlantrunk disable sub1
34.14 switch qschedule Commands
Use these commands to set a port's queuing method and/or priority weight.
34.14.1 switch qschedule set Command
Syntax:
switch qschedule set <giga-port> spq
or
<giga-port> wrr <wt0> <wt1> <wt2> <wt3> <wt4> <wt5> <wt6> <wt7>
902
=
This represents Gigabit Ethernet uplink ports, subtending
<giga-port>
ports or all ports. Use
trunking is not enabled. Use
trunking is enabled.
=
This represents Gigabit Ethernet uplink ports, subtending ports or
all ports. Use
sub1|sub2|up1|up2|all i
enabled. Use
tsub|tup|all
sub1|sub2|up1|up2|all i
tsub|tup|all
f trunking is not
if trunking is enabled.
MSC1000G/1024G/1224G Series User's Guide
f
if