ZyXEL Communications MSC1024G Series User Manual page 100

Chapter 5 Access Control List Screens
Figure 44 DHCP Snooping
The following table describes the labels in this screen.
Table 15 DHCP Snooping
LABEL
Slot
Port
Load
Enable
Static IP1 .. 3
Apply
Cancel
100
DESCRIPTION
Use the drop-down list boxes to select a DSL port on a line card for which you
want to configure DHCP snooping.
Click Load to display the port's current settings.
Select the check box to activate DHCP snooping on the specified DSL port.
Specify the static IP addresses of frames for which you want the switch to allow
passage on the port.
Enter the IP address in dotted decimal notation. For example, 192.168.1.100.
Note: Make sure the specified static IP addresses are not in the
DHCP client pool on the DHCP server.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
MSC1000G/1024G/1224G Series User's Guide