Xvlan Port Setup Line Card Screen - ZyXEL Communications MSC1024G Series User Manual

Chapter 11 Subscriber Port Setup Screens
Table 131 Port > Xvlan (continued)
LABEL
Svid
Cvid-S
Select
Cvid
Svid
Cvid-S
Apply
Cancel
ID
State
Card Type
Up Time
Firmware

11.31.2 xVLAN Port Setup Line Card Screen

Click Port > Xvlan in the navigation panel to open the Xvlan Port Setup screen. Click the
slot number of an active VDSL line card to open the following screen. Use this screen to delete
xVLAN settings from individual VDSL ports.
Figure 196 Port > Xvlan: Line Card
306
DESCRIPTION
This is the service provider VLAN ID used on the service provider's network.
This applies to the VLC13XXG cards. This is the translated customer VLAN ID
used on the service provider's network.
Select an entry's radio button and then click Modify to be able to edit it or click
Delete to remove it.
Specify the original customer VLAN ID (from 1 to 4094) of the subscriber traffic to
which this xVLAN entry is too apply.
Specify the service provider VLAN ID (from 1 to 4094) to use for the subscriber
traffic when forwarding it to the service provider's network.
This applies to the VLC13XXG cards. Specify the customer VLAN ID (from 1 to
4094) to use for the subscriber traffic when forwarding it to the service provider's
network.
Enter 0 to not use a customer VLAN ID for the subscriber traffic when forwarding it
to the service provider's network.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
This column lists the slot numbers of the line cards. Click the ID number of an
active DSL line card to go to a screen where you can copy a DSL port's settings to
another DSL port.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could
be due to the card starting, a firmware upgrade in progress or a malfunction. See
Section 39.7 on page 974 for what to do if the line card stays stuck in the inactive
state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it
was started.
This field displays the current firmware version installed on the line card.
MSC1000G/1024G/1224G Series User's Guide