Switch Cfm Lbr Screen - ZyXEL Communications MSC1024G Series User Manual

15.17.5 Switch CFM LBR Screen

Click Switch > CFM > LBR to display the screen shown next. Use this screen to enable or
disable loopback testing on individual ports. LBR stands for Loop Back Response.
Figure 352 Switch CFM > LBR
The following table describes the labels in this screen.
Table 261 Switch CFM > LBR
LABEL
MSC1000G
Apply
Slot
Port
Load
Enable
Apply
Cancel
ID
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Enable or disable loopback testing on the MSC's ports.
Click Apply to save the changes in this section to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Use the drop-down list boxes to select a DSL port on a line card for which you
want to enable or disable loopback testing.
Click Load to display the port's current settings.
Enable or disable loopback testing on the DSL port.
Click Apply to save the changes in this section to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields.
This is the slot number of a line card. Click the index number of an active line card
to display a screen that lists whether loopback testing is enabled or disabled for
each of the line card's ports.
Chapter 15 Switch Screens
503