34.7 switch garptimer Commands
Use the
switch garptimer
34.7.1 switch garptimer show Command
Syntax:
switch garptimer show
This command displays the system's GARP timer settings, including the join, leave and leave-
all timers. An example is shown next.
ras> switch garptimer show
join time
leave time
leaveall time (ms): 10000
ras>
34.7.2 switch garptimer join Command
Syntax:
switch garptimer join <join msec>
where
<join msec>
This command sets the system's join period timer for GVRP in milliseconds.
Switches join VLANs by making a declaration. A declaration is made by issuing a Join
message using GARP. GARP timers set declaration timeout values.
The following example sets the Join Timer to 300 milliseconds.
ras> switch garptimer join 300
34.7.3 switch garptimer leave Command
Syntax:
switch garptimer leave <leave msec>
where
<leave msec>
This command sets the system's leave period timer for GVRP in milliseconds.
MSC1000G/1024G/1224G Series User's Guide
commands to configure GARP timeout periods.
(ms): 200
(ms): 600
=
This sets the duration of the Join Period timer for GVRP in milliseconds.
Each port has a Join Period timer. The allowed Join Time range is
between 100 and 32767 milliseconds; the default is 200 milliseconds.
=
This sets the duration of the Leave Period timer for GVRP in milliseconds.
Each port has a single Leave Period timer. Leave Time must be two times
larger than Join Timer; the default is 600 milliseconds. The allowed Leave
Time range is between 201 and 65534 milliseconds; the default is 600
milliseconds.
Chapter 34 switch Commands
885