ZyXEL Communications MSC1024G Series User Manual page 69

Table 3 Navigation Panel Links (continued)
LINK
OAM
IMA
Switch
Switch Setup
MSTP
Switch Port
Setup
CFM
OAM
Sys
Access Control
General Setup
IP Setup
Unix SysLog
User Account
Monitor
VLAN
VLAN
Port Setting
VoIP
ARP
Countrycode
IP
Route
Number Plan
VOP H248
Local Help
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
This link takes you to a screen where you can view the Ethernet OAM (Operational,
Administration and Maintenance) statistics for Ethernet line card ports.
This link takes you to a screen where you can view E1 port statistics.
This link takes you to a screen where you can set up global switch parameters such
as GARP, link aggregation, priority queues and a port's queuing method.
This link takes you to a screen where you can configure spanning tree settings to
prevent network loops.
This link takes you to a screen where you can configure settings for individual
Gigabit Ethernet interfaces.
This link takes you to screens where you can configure settings for connectivity fault
management.
This link takes you to a screen where you can set the Ethernet OAM (Operational,
Administration and Maintenance) mode for Ethernet line card ports.
This link takes you to screens where you can configure SNMP and remote
management.
This link takes you to a screen where you can configure general identification
information about the switch and the time and date settings.
This link takes you to a screen where you can configure the in-band and out-of-
band management IP addresses and subnet masks.
This link takes you to a screen where you can configure the syslog settings.
This link takes you to screens where you can configure a user account and its level
of access privileges and authentication settings.
This link takes you to screens where you can configure the hardware monitor alarm
thresholds.
This link takes you to screens where you can configure static VLANs.
This link takes you to screens where you can configure port VLAN settings.
This link takes you to a screen where you can configure ARP (Address Resolution
Protocol) settings for VoIP cards.
This link takes you to a screen where you can configure regional VoIP settings.
This link takes you to a screen where you can configure TCP/IP settings on the
VoIP line cards.
This link takes you to a screen where you can configure routing settings for the VoIP
line cards.
This link takes you to a screen where you can configure number plans which control
how dialed numbers of certain types can be automatically modified before onward
transmission.
This link takes you to a screen where you can configure media gateways on VoIP
line cards.
This link takes you to a screen where you can configure which local subscribers are
called instead of public emergency (or other) numbers in the event that the link to
the VoIP provider is not available.
Chapter 3 The Web Configurator
69