Chapter 32 profile Commands
This command configures an Ethernet subscriber line ingress and egress rate profile.
The following creates an Ethernet subscriber line profile named test that limits ingress and
egress traffic to 12,800 Kbps.
ras>
profile ratelimit set test 12800 12800
32.14.4 profile ratelimit show Command
Syntax:
profile ratelimit show [<profile>]
This command displays the name(s) of the rate limit profile(s) you have configured. Specify a
profile to see it's details.
ras> profile ratelimit show
rate limit profile(s):
----------------------
1. DEFVAL
2. test
ras> profile ratelimit show DEFVAL
rate limit profile : DEFVAL
ingress rate : 0 kbps
egress rate
32.15 profile shdsl Commands
Use the
profile shdsl
32.15.1 profile shdsl set Command
Syntax:
profile shdsl set <profile> <min-rate> <max-rate>
[annexa|annexb 2wire|4wire|mpair4
[lp_off | lp_on_cur [curr_margin] | lp_on_wc [worst_margin]]]
where
<profile>
<min-rate>
<max-rate>
annexa|annexb
792
: 0 kbps
commands to configure SHDSL profiles.
The descriptive name for the profile.
=
The minimum transmission rate in Kbps (192~4096).
=
=
The maximum transmission rate in Kbps. (192~4096)
=
The region setting, annexb is the default.
: DSL over POTS.
annexa
annexb
: DSL over ISDN.
MSC1000G/1024G/1224G Series User's Guide