ZyXEL Communications MSC1024G Series User Manual page 562

Chapter 18 VoIP
The following table describes the labels in this screen.
Table 296 The VoIP > Number Plan Screen
LABEL
Name
1~16
Pattern
Rule
Apply
New
Cancel
Index
Name
Select
562
DESCRIPTION
Enter the name of the number plan table. If you are configuring a new number plan
table, you can enter the name of the new table here. If you are looking an existing
number plan table, this field is not editable.
This is the pattern / rule number. When the system checks a dialed number against
the table, it checks the patterns in numerical order from 1 ~ 16, so ordering is
important.
This is the dialed number for which this table entry applies.
Allowed characters are:
• Numerals "0" ~ "9"
• "x" (representing one digit)
• Asterisk "*" (representing one or more digits)
• Period "." (representing zero or more repetitions of the digit or range preceding
it, for example "5." and "[1~3].").
• Tilde "~" (representing a range of digits, for example "[3~9]"). The tilde must be
used in brackets, and characters to either side of the tilde must both be digits.
• Comma"," (representing a choice of digits. for example "[4,9]"). The comma must
be used in brackets, and characters to either side of the comma must both be
digits.
• Pipe "|", separating number plan patterns.
• Brackets "[" and "]" (representing an allowed range, for example "[1,3~5]").
• A maximum of one pair of parentheses "(" and ")"
For example, if a Pattern String entry is "0021*", the corresponding Rule String is
applied to any dialed number starting from "0021".
This is the rule applied to the corresponding Pattern String.
Allowed characters are:
• "\c" = the Pattern String is replaced by the countrycode (specified in the
relevant call service profile).
• "\d" = the Pattern String is replaced by the national destination (region) code
(specified in the relevant call service profile).
• "\1" = the Pattern String is replaced by the numbers enclosed by the
parentheses "(" and ")" in the Pattern String
• "deny" = the Pattern String is not allowed.
For example:
• If the Pattern String is "00244(*)", the Rule String is "\c\1" and the country code in
the relevant call service profile is "28", the dialed number "00244123456"
becomes "28123456".
• If the Pattern String is "010(*)", the Rule String is "\d\1" and the national
destination code in the relevant call service profile is "01473", the dialed number
"010456789" becomes "01473456789".
• If the Pattern String is "0440(1*)" and the Rule String is "\1", the dialed number
"04401473987654" becomes "1473987654".
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config
Save on the navigation panel and then the Save button to save your changes to the
non-volatile memory when you are done configuring.
While you are modifying a number plan table, you can click New to start configuring
a fresh table without saving your changes.
Click Cancel to start configuring the screen again.
This is an incremental number indicating the order in which the number plan tables
were created.
These are the names of individual tables. The DEFVAL table always exists, and is
assigned to all ports by default.
Select the number plan table you wish to modify or delete.
MSC1000G/1024G/1224G Series User's Guide