Sys Timeserver Set Command; Sys Timeserver Sync Command; Sys Info Chassis Command - ZyXEL Communications MSC1024G Series User Manual

35.3.13 sys timeserver set Command

Syntax:
sys timeserver none
sys timeserver daytime <ip-address> [sync]
sys timeserver time|ntp <ip-address> <utc[<+|->0100~1200]> [sync]
where
none
daytime
time|ntp
<ip-address>
<utc[<+|->
0100~1200]>
[sync]
This command sets the system to use a time server.
The following example sets the system to use NTP protocol to access a time server at IP
address 140.112.2.189 and sets the system's time zone to eight hours ahead of UTC. It also has
the system synchronize the time with the time server.
ras> sys timeserver set ntp 140.112.2.189 utc +0800 sync
sync with time server...success
ras>

35.3.14 sys timeserver sync Command

Syntax:
sys timeserver sync
This command has the system get the time and date from the time server. An example is shown
next.
ras> sys timeserver sync
sync with time server...success
ras>

35.3.15 sys info chassis Command

Syntax:
sys info chassis <chassis>
MSC1000G/1024G/1224G Series User's Guide
= Sets the system to not use a time server.
The Daytime time service protocol (RFC 867). When you select this
=
format, the switch displays the day, month, year and time with no time
zone adjustment. When you use this format it is recommended that you
use a Daytime timeserver within your geographical time zone.
The time service protocol.
=
time: Time (RFC 868) format displays a 4-byte integer giving the total
number of seconds since 1970/1/1 at 0:0:0.
ntp: NTP Network Time Protocol (RFC 1305) is similar to Time (RFC
868).
The IP address of the time server.
=
The time difference between UTC (Universal Time Coordinated, formerly
=
known as GMT, Greenwich Mean Time) and your time zone.
= This sets the system to synchronize with the time server.
Chapter 35 sys Commands
915