Table of Contents
Advertisement
where
<vid>
<mode>
This command enables DHCP relay on a VLAN and sets the relay mode.
The following example creates a configuration entry and enables DHCP relay mode 1 on
VLAN 10.
ras> acl dhcprelay82 set 10
ras> acl dhcprelay82 enable 10 2
21.3.3 acl dhcprelay82 info Command
Syntax:
acl dhcprelay82 info <vid> <string>
where
<vid>
<string>
This command sets the relay agent information to be included in client DHCP requests before
forwarding. A DHCP server implements network information (such as IP address) policies
based on the relay agent information.
The following example sets the system to add a string (
before forwarding them to the DHCP server.
ras> acl dhcprelay82 info test
21.3.4 acl dhcprelay82 optionmode Command
Syntax:
acl dhcprelay82 optionmode <vid> private|tr101 [vid on|off]
This command selects the method (Private or TR-101) in which DHCP relay information is
sent and whether or not the VLAN ID is transmitted within the packet on the specified VLAN.
The vid on|off option applies to the TR-101 mode only. See
more information on Private and TR-101 modes.
MSC1000G/1024G/1224G Series User's Guide
=
ID of the VLAN to which this setting applies.
Sets the relay mode.
=
1:
Activates DHCP relay service and include option 82 information in the
client DHCP requests for this VLAN.
Disables DHCP relay service but include option 82 information in the client
2:
DHCP requests. Before broadcasting, the switch adds option82 information to
DHCP requests.
=
ID of the VLAN to which this setting applies.
=
Up to 23 English keyboard characters of additional information to add to the
DHCP client TCP/IP configuration requests that are relayed to a DHCP server.
Examples of information you could add would be the name of the system or
the ISP.
Chapter 21 acl Commands
) to client DHCP request packets
test
Section 5.2 on page 96
for
591
Advertisement
Table of Contents
Troubleshooting
