Switch Dot3Ad Commands - ZyXEL Communications MSC1024G Series User Manual

Chapter 34 switch Commands
This command sets a maintenance association intermediate point. The following shows an
example.
ras> switch cfm mip set
34.5.3.18 switch cfm show
Syntax:
switch cfm show [<md-name> <ma-name>]
This command displays MDs, a detailed MD or a detailed MA information.
Three examples (show all MDs, a specified MD's detail, a specified MA's detail) are shown
next.
ras> switch cfm show
status
no. of maintenance domain : 2
md name
-------------------------------- ----- ---------
MD_0
MD_1
ras>
ras> switch cfm show MD_0
maintenance domain
level
no. of maintenance association : 1
ma name
---------------- ----------- ------------ ----------
L2SW-DSLAM
ras>
ras> switch cfm show MD_0 L2SW-DSLAM
maintenance association : L2SW-DSLAM
cci interval
primary vlan
no. of maintenance ep
maintenance ep list
vlan list
MEP id slot-port direction Priority cciEnabled
------ --------- --------- -------- ----------
1
mip:

34.6 switch dot3ad Commands

Use the
switch dot31d
880
: enabled
cciInterval primary vlan no. of MEP
4
: 4
: 1
: 1
: 1 2 1001
: 1
enet1 down
2-22
commands to configure static and dynamic (LACP) port trunking.
level no. of ma
0 1
7 0
: MD_0
: 0
1 1
7 enabled
MSC1000G/1024G/1224G Series User's Guide