Cluster Member Management - ZyXEL Communications MSC1024G Series User Manual

Table 53 Cluster: Configuration (continued)
LABEL
Select
Password
Member ID
Apply
Cancel
Refresh

7.3.1 Cluster Member Management

Click Cluster > Status screen of the cluster manager and then click an Index hyperlink from
the list of members to go to that cluster member's web configurator. The top of the cluster
member's web configurator screen displays cluster information.
Figure 89 Cluster Member Web Configurator Screen
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Select this check box and then configure the Password and the Member ID
fields and click the Apply button to add a cluster member candidate to the
cluster.
Each cluster member's password is its management password. When you
select a DSLAM to be a cluster member, enter its management password.
If a member DSLAM's management password changes, then it cannot be
managed from the cluster manager. Its State displays as Error in the Cluster >
Status screen and a warning icon (
screen's Membership Configuration list. You need to delete the member from
the Membership Configuration list and re-add it from the Cluster Candidate
list.
This is the index number of a cluster member.
Click Apply to add a cluster member candidate to the cluster. The MSC checks
the password with the device. The changes in this section of the screen are
saved to the system's volatile memory. The system loses these changes if it is
turned off or loses power, so use the Config Save on the navigation panel and
then the Save button to save your changes to the non-volatile memory when
you are done configuring.
Click Cancel to reset the fields.
Click Refresh to update the list of suitable candidates found by auto-discovery.
Chapter 7 Cluster Screens
) appears in the Cluster > Configuration
173