Chapter 21 acl Commands
21.8.4 acl maccount show Command
Syntax:
acl maccount show <slot>
This command displays the MAC count settings for the DSL port(s). The following example
displays the MAC count settings for slot 5.
ras> acl maccount show 5
[slot5] maccount
port enable count
----- ------ -----
5- 1
5- 2
5- 3
5- 4
-------------------------- [snip] --------------------------
5-44
5-45
5-46
5-47
5-48
21.9 acl macfilter Commands
Use the MAC filter commands to allow only incoming frames from MAC (Media Access
Control) address(es) that you specify. MAC filter commands are listed next. You may specify
up to ten MAC addresses per port.
You cannot enable both MAC filtering and MAC count on the same port at the
same time.
21.9.1 acl macfilter delete Command
Syntax:
acl macfilter delete <slot-port> <mac>
where
This command removes a configured source MAC address from a line card's specified DSL
port.
602
-
5
-
5
-
5
-
5
-
5
-
5
-
5
-
5
-
5
The source MAC address in "a0:c5:12:34:56:78" format.
<mac>
=
MSC1000G/1024G/1224G Series User's Guide