ZyXEL Communications MSC1024G Series User Manual page 572

Chapter 18 VoIP
Table 302 VoIP > Interface
LABEL
Primary /
Secondary
Slot
MG Enable
MG name
MG Port
H248 Profile
BHCA Peak
/ Average
Slave IP
Apply
New
Cancel
Interface ID
Interface IP
VID
Primary /
Secondary
Slot
MG name
Select
Modify
572
DESCRIPTION
Enter the slot numbers of the interface's active and backup signaling cards.
Select this to activate the media gateway.
Enter a name for the media gateway (up to 31 ASCII characters; spaces are not
allowed).
Enter a port number for this media gateway. Each media gateway in an interface must
use a different port. The default is port 2944.
Select the H.248 profile this media gateway is to use. The H.248 profile defines the
media gateway controller(s) associated with this media gateway. Define H.248 profiles
in the Profile > VoIP H248 screen.
Busy Hour Call Attempts (BHCA). Specify the maximum number of call attempts
allowed per second and per hour.
Specify the IP addresses of the media cards that are part of this interface.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
While you are modifying an H.248 interface's settings, you can click New to start
configuring a fresh table without saving your changes.
Click Cancel to start configuring the screen again.
This is the number of the H.248 interface.
This is the H.248 interface's IP address.
This is the H.248 interface's VLAN.
These are the slot numbers of the interface's active and backup signaling cards.
This is the name of the media gateway.
Select the entry you wish to modify or delete.
Select an entry and click this in order to edit its configuration.
MSC1000G/1024G/1224G Series User's Guide