Chapter 15 Switch Screens
Table 250 MSTP: Port (continued)
LABEL
P2P
Apply
Cancel
15.10.3 MSTP Configuration Example
This section shows you how to configure MSTP settings for the network example shown. In
this network example, there are two VLANs on two spanning tree instances.
Figure 338 MSTP Network Example 2
1 Log into the web configurator and access the MSTP-Bridge screen.
2 Specify a descriptive name in the Config Name field for the MSTP region.
3 Enter a number in the Revision Level field.
4 To create VLAN-to-MSTI mapping, set the MSTID, Start VID and End VID fields and
click Apply. For this example, map VLAN 1 to MSTID 1 and VLAN 2 to MSTID 2.
488
DESCRIPTION
Set a point-to-point link between ports to increase the speed of convergence by
allowing the network to determine the designated port faster. The port must be
connected directly to another switch port.
Select Enable to activate this feature on a full-duplex port that is connected
directly to another switch port.
Select Disable to deactivate this feature on the port that is in half-duplex mode.
Select Auto to have the system automatically determine if the port is full-duplex or
half-duplex.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to start configuring this screen again.
MSC1000G/1024G/1224G Series User's Guide