E1 Port Setup Advanced - ZyXEL Communications MSC1024G Series User Manual

The following table describes the fields in this screen.
Table 129 E1 Port Setup: Line Card
LABEL
UP
Copy
Apply
Cancel
Port
Enable
Customer
Information
Select

11.30.2 E1 Port Setup Advanced

Click Port > E1 in the navigation panel to open the E1 Port Setup screen. Click the slot
number of an active IMA line card and click a port number to display the configuration screen.
Use this screen to configure an E1 port's detailed settings.
Figure 193 E1 Port Setup: Advanced
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Click this to return to the previous screen.
Select a port in the Select column and then do the following to copy the settings
from the port to another port or ports.
1. Click Copy.
2. Select to which IMA line card you want to copy the settings.
3. Select to which ports on the line card you want to copy the settings. Use
Select All to select every port. Use Select None to clear all of the check
boxes.
4. Click Apply to paste the settings.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
This is the number of an E1 port on the line card.
Select this to enable an E1 port or clear this to disable it.
This field displays the customer information configured for an E1 port. You can
also type up to 47 alphanumeric characters to update the information. Spaces are
allowed.
Select a port here and then use the Copy button to copy the port settings to
another port or ports.
Chapter 11 Subscriber Port Setup Screens
303