Pppoa To Pppoe (Pae) Translation; Port Paepvc Delete Command - ZyXEL Communications MSC1024G Series User Manual

Chapter 31 port Commands
where
This command sets a name for the specified subscriber port(s).
The following example sets port 5 on the line card in slot 2 to use the name Bob.
ras> port name 2-5 bob

31.24 PPPoA to PPPoE (PAE) Translation

Before migrating to an Ethernet infrastructure, a broadband network might consist of PPPoA
connections between the CPE devices and the DSLAM and PPPoE connections from the
DSLAM to the BRAS (Broadband Remote Access Server). The following figure shows a
network example.
Figure 396 Mixed PPPoA-to-PPPoE Broadband Network Example
In order to allow communication between the end points (the CPE devices and the BRAS),
you need to configure the DSLAM to translate PPPoA frames to PPPoE packets and vise
versa.
When PPPoA packets are received from the CPE, the ATM headers are removed and the
system adds PPPoE and Ethernet headers before sending the packets to the BRAS. When the
system receives PPPoE packets from the BRAS, PPPoE and Ethernet headers are stripped and
necessary PVC information (such as encapsulation type) is added before forwarding to the
designated CPE.
You can use the

31.24.1 port paepvc delete Command

Syntax:
port paepvc delete <slot-port-vpi/vci>
This command removes a PAE PVC.
730
= A name to identify the subscriber port.
<name>
PPPoA
command to create PVCs for PAE translation.
port paepvc
BRAS
PPPoE
MSC1000G/1024G/1224G Series User's Guide