Table 328 show Commands (continued)
COMMAND
vlan
voip
33.3 show Commands
Use these commands to display runtime status information.
33.3.1 show adsl Commands
Use the
show adsl
33.3.1.1 show adsl linedata Command
Syntax:
show adsl linedata <slot-port>
This command displays a ADSL port's line bit allocation.
Discrete Multi-Tone (DMT) modulation divides up a line's bandwidth into tones. This
command displays the number of bits transmitted for each tone. This can be used to determine
the quality of the connection, whether a given sub-carrier loop has sufficient margins to
support ADSL transmission rates, and possibly to determine whether certain specific types of
interference or line attenuation exist. Refer to the ITU-T G.992.1 recommendation for more
information on DMT.
The better (or shorter) the line, the higher the number of bits transmitted for a DMT tone. The
maximum number of bits that can be transmitted per DMT tone is 15.
"usBit table" displays the number (in hexadecimal format) of bits transmitted per DMT tone
for the upstream channel (from the subscriber's DSL modem or router to the DSL line card).
MSC1000G/1024G/1224G Series User's Guide
[<vid>]|[
<start-vid>
<end-vid>]
h248
interface
<id>
media <id>
<media>
termination
info
*|<id>-
<media>-
<port> |
<id> <name>
termination
state
sip
serverstate
<slot>
[<proxysvr-
ip> |
<proxysvr-
dn>]
commands to display the line information for an active ADSL line.
Chapter 33 show Commands
DESCRIPTION
Displays current VLANs.
Displays the status of the specified
H.248 interface.
Displays the status of the specified
H.248 media card.
Displays H.248 termination names.
Displays H.248 termination states.
Displays the status of SIP proxy server
while the "local call" feature is enabled.
proxysvr-ip: The IP address of the
SIP proxy server.
proxysvr-dn: The domain address
of the SIP proxy server.
P
L
L
L
L
L
L
825