11.28 ENET Port Setup
Click Port > ENET in to open the following screen. Use this screen to configure settings for
individual subscriber Ethernet ports.
Figure 183 ENET Port Setup
The following table describes the fields in this screen.
Table 122 ENET Port Setup
LABEL
Slot
Port
Load
Enable
Customer
Information
TEL
Flow Control
Frame Type
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Select the number of a line card's slot. The corresponding subscriber port setup
screen for the type of line card you selected automatically displays.
Select the number of a port on the line card.
Click Load to display the port's settings in the fields below.
Select this check box to turn on this port.
Enter information to identify the subscriber connected to this port. You can use up
to 31 printable English keyboard characters (including spaces and hyphens).
Enter information to identify the telephone number of the subscriber connected to
this port. You can use up to 15 English keyboard characters (including spaces and
hyphens).
Select this check box to turn on flow control on a port. See
page 490
for more on flow control.
Select all to have the interface accept all Ethernet frames. Select tag to have the
interface only accept frames with an IEEE 802.1Q VLAN tag.
Chapter 11 Subscriber Port Setup Screens
Section 15.11.2 on
291