Alarm E1 Profile Screen - ZyXEL Communications MSC1024G Series User Manual

Table 173 Profile > Dialplan
LABEL
Apply
New
Cancel
Index
Name
Select
Modify
Delete

13.28 Alarm E1 Profile Screen

Click Profile> Alarm E1 in the navigation panel to open the following screen. Use this screen
to configure alarm profiles for the E1 ports. Later you can apply the alarm E1 profiles to E1
ports in the E1 Port Setup screens.
Alarm E1 profiles define E1 port alarm thresholds. The system sends an alarm trap and
generates a syslog entry when the thresholds of the alarm profile are exceeded.
Figure 259 Alarm E1 Profile
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
While you are modifying a profile, you can click New to start configuring a fresh profile
without saving your changes.
Click Cancel to start configuring the screen again.
This is an incremental number indicating the order in which the profiles were created.
This is the name of the profile.
Select the profile you wish to load or delete.
Select a profile and click this in order to edit its configuration.
Select a profile and click this to delete the profile. Once deleted, information cannot be
retrieved.
Chapter 13 Profile Screens
395