The following example turns on the flow control on port 5 on the ELC in slot 4.
ras> port enet flowctrl enable 4-5
31.10.8 port enet frametype Command
Syntax:
port enet frametype <slot-port> all|tag
where
all|tag =
This command sets the specified Ethernet (ELC) subscriber port(s) to accept all Ethernet
frames or only those with an IEEE 802.1Q VLAN tag.
The following example sets port 5 on the ELC in slot 4 to accept only tagged frames.
ras> port enet frametype 4-5 tag
31.10.9 port enet priority Command
Syntax:
port enet priority <slot-port> <priority>
where
This command sets the default ingress user priority of the specified Ethernet (ELC) subscriber
port(s).
The following example sets the default priority of port 5 on the ELC in slot 4 to 3.
ras> port enet priority 4-5 3
31.10.10 port enet pvid Command
Syntax:
port enet pvid <slot-port> <vid>
where
This command sets the Port VLAN ID assigned to untagged frames or priority frames (0 VID)
received on this Ethernet subscriber port(s).
MSC1000G/1024G/1224G Series User's Guide
Specifies all Ethernet frames (tagged and untagged) or only tagged Ethernet
frames.
The default ingress priority (0~7). 0 is the lowest priority level
=
<priority>
and 7 is the highest.
=
The default Port VLAN ID (PVID) assigned to untagged frames or
<pvid>
priority-tagged frames received on this port (1~4094).
Chapter 31 port Commands
713