ZyXEL Communications MSC1024G Series User Manual page 898

Chapter 34 switch Commands
This command disables MSTP on the specified Gigabit Ethernet interface port (or all of them)
in the specified spanning tree instance. All MSTP packets to/from the specified spanning tree
instance will be dropped on the port.
The following example disables MSTP on unlink port 1 in spanning tree instance 2.
ras> switch port mstp disable up1 2
34.12.8.2 switch port mstp edgeport Command
Syntax:
switch port mstp edgeport <giga-port> <mstid> <enable|disable>
This command enables or disables the specified Gigabit Ethernet interface as an edge port that
connects to a non-SPT device (such as a computer or hub).
The following example sets subtending port 2 as an edge port.
ras> switch port mstp edgeport sub2 enable
34.12.8.3 switch port mstp enable Command
Syntax:
switch port mstp enable sub1|sub2|up1|up2|all <mstid>
This command sets the specified Gigabit Ethernet interface to participate in the spanning tree
instance.
The following example activates MSTP on all Gigabit Ethernet interfaces in the spanning tree
instance 3.
ras> switch port mstp enable all 3
34.12.8.4 switch port mstp p2plink Command
Syntax:
switch port mstp p2plink <giga-port> auto|enable|disable
where
auto
enable
disable
Enable a point-to-point link between Gigabit Ethernet interfaces to increase the speed of
convergence by allowing the network to determine the designated port faster. The port must be
connected directly to another switch port.
898
The switch automatically determines if the link is point-to-point based on the
=
port's duplex mode setting.
Activates this feature on a full-duplex port that is connected directly to
=
another switch port.
Deactivates this feature on the port that is in half-duplex mode.
=
MSC1000G/1024G/1224G Series User's Guide