Monitor Screen - ZyXEL Communications MSC1024G Series User Manual

Managment switch card

Hide thumbs Also See for MSC1024G Series:

Table of Contents

The following table describes the labels in this screen.

Table 271 User Account

Retype Password

16.8 Monitor Screen

Click Sys > Monitor from the navigation panel to open the following screen. Use this screen

to view hardware status information and set the hardware monitor high and low thresholds for

generating alarms.

MSC1000G/1024G/1224G Series User's Guide

Select this check box to activate the administrator account.

Type a user name for the account

Type a password for the account.

Type the password again to make sure you have entered it properly.

Select the administrator account's level of access privileges.

Select high to allow the administrator to perform all types of system configuration,

including the management of administrator accounts.

Select middle to allow the administrator to configure the system through the web

configurator but not manage administrator accounts.

Select low to allow the administrator read-only access to the web configurator

Click Apply to save the changes in this screen to the system's volatile memory.

The system loses these changes if it is turned off or loses power, so use the

Config Save on the navigation panel and then the Save button to save your

changes to the non-volatile memory when you are done configuring.

Click Cancel to begin configuring this screen afresh.

This column numbers the administrator account entries.

This column displays a "V" if the administrator account is turned on or a "-" if the

account is turned off.

This column displays the user names of the accounts.

This column displays the level of access privileges of the accounts.

Select one or more account entries' check boxes and then use the Delete button

to remove it (or them).

Chapter 16 Sys Screens

Msc1224g series Msc1000g series