Chapter 4 Tutorials
4 Configure the H.248 interface.
Use the VoIP > Interface screen (see
• Select the number of the H.248 interface you want to configure (1 in this example) and
click Load.
• Enter the H.248 interface's IP address and subnet mask for communicating with the
MGC (172.16.19.200/24 in this example.
• Enter the VID of the H.248 interface's VLAN (1 in this example.
• Enter the Primary slot. This is the slot with the H.248 signaling card (3 in this
example). This example has no secondary slot so leave the field set to 0.
• Select MG Enable.
• Enter the MG name (MG1 in this example).
• Select the H248 Profile this H.248 interface uses (MEGACO in this example).
• In the first Slave IP field, specify the IP address of the VOP (192.168.3.174).
• Click Apply.
Figure 28 H.248 Interface Example
82
Section 18.14 on page
570).
MSC1000G/1024G/1224G Series User's Guide