The Voip Ip Screen - ZyXEL Communications MSC1024G Series User Manual

18.6 The VoIP IP Screen

Use this screen to specify the IP address, subnet mask, VLAN ID and DNS information for
each of the VoIP line cards managed by the IES. Click VoIP > IP. The following screen
displays.
Figure 384 The VoIP > IP Screen
The following table describes the labels in this screen.
Table 294 The VoIP > IP Screen
LABEL
Slot
IP
Mask
Vid
DNS
Apply
Cancel
Slot
IP Mask
Vid
DNS
Select
Modify
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Enter the slot number of the line card you want to configure.
Enter the IP address the line card uses for VoIP communications.
Enter the IP address in dotted decimal notation. For example,
192.168.1.100.
Enter the number of bits in the VoIP line card's subnet mask.
Enter the number of the VLAN that this static VoIP line card is to use.
Enter the DNS server's IP address for this VoIP line card.
Click Apply to save the changes in this screen to the system's volatile
memory. The system loses these changes if it is turned off or loses power,
so use the Config Save on the navigation panel and then the Save button
to save your changes to the non-volatile memory when you are done
configuring.
Click this to start configuring the screen again.
This displays a VoIP line card's slot number.
This displays a VoIP line card's IP address, if one is configured (if an IP
address is not configured, 0.0.0.0 displays).
This displays a VoIP line card's VLAN ID, if one is configured (if a VLAN
ID is not configured, 0 displays).
This displays a VoIP line card's DNS server IP address, if configured (if a
DNS server IP address is not configured, 0.0.0.0 displays).
Select the line card you wish to modify.
Select a line card and click this in order to edit its configuration.
Chapter 18 VoIP
559