Static Multicast Slot Screen - ZyXEL Communications MSC1024G Series User Manual

Managment switch card

Hide thumbs Also See for MSC1024G Series:

Table of Contents

Table 69 Static Multicast (continued)

10.4.1 Static Multicast Slot Screen

Click Multicast > Static Multicast in the navigation panel to display the Static Multicast

screen. Type a VID and a group IP and click Apply to display entries in the first table. Click

the slot number of an active line card to open the following screen. Use this screen to set which

of the line card's ports belong to the static multicast group.

Figure 117 Static Multicast Slot

MSC1000G/1024G/1224G Series User's Guide

Click Apply to save the changes in this screen to the system's volatile memory. The

system loses these changes if it is turned off or loses power, so use the Config Save

on the navigation panel and then the Save button to save your changes to the non-

volatile memory when you are done configuring.

After you click Apply, entries display in the first table so you can edit them. Click New

if you want to configure a different static multicast group.

Click Cancel to begin configuring the screen again.

Select a static multicast group's radio button and click Modify to display the static

multicast group in the table above so you can edit it.

Select a static multicast group's radio button and click Delete to remove the static

multicast group.

This is the number of the VLAN that this static multicast group uses.

This is the static multicast IP address.

This section lists the VLAN membership setting of the ports on the management

switch card. An "F" indicates that the port is a permanent member of the static

multicast group. An "X" indicates that the port is forbidden (blocked) from joining the

static multicast group. An "-" indicates that the port is a normal member and can join

the VLAN dynamically. See

This section displays the numbers of any slots that are fixed members of the static

multicast group. All other slots are represented by a "-".

Select a static multicast group's radio button and then click Modify to be able to edit

it or click Delete to remove it.

Chapter 10 Multicast Screens

Table 282 on page 533

for more on VLAN registration.

Msc1224g series Msc1000g series