Ip Commands; Ip Arp Flush Command - ZyXEL Communications MSC1024G Series User Manual

Chapter 28 ip Commands
Table 319 ip Commands (continued)
COMMAND
set
tracert

28.2 ip Commands

The following shows general IP commands that help with the management of the IP
parameters.

28.2.1 ip arp flush Command

Syntax:
ras> ip arp flush
This command clears the system's IP Address Resolution Protocol (ARP) table.
658
inband|outb
and <ip-
address>[/
<netmask>]
[<inband-
vid>]
<ip-
address>
DESCRIPTION
Sets the management IP address,
subnet mask and in-band management
VLAN ID.
ip-address: '0.0.0.0' disables a
management interface.
inband-vid: The VLAN ID for this
interface.
Note: Misconfiguring the
management IP address
or VLAN ID may lock
yourself out from
managing the device.
Note: It is highly recommended
that you use the sys
reboot <seconds>
command before using
any commands that may
lock you out from
managing the device. Use
the sys reboot
cancel command to
cancel the scheduled
reboot before time is up
when you are sure that
you have the correct
configuration.
Sends a traceroute packet to the IP
address (in the field to the left) and uses
the response to determine the path a
packet takes to that IP address.
MSC1000G/1024G/1224G Series User's Guide
P
M
L